MIB Discovery

Recherche :

1930 modules enregistrés
Chemin
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 2 (mgmt). 1 (mib-2). 16 (rmon). 19 (probeConfig). 10 (serialConfigTable). 1 (serialConfigEntry). 3 (serialTimeout)
OID : 1.3.6.1.2.1.16.19.10.1.3
TXT : iso. org. dod. internet. mgmt. mib-2. rmon. probeConfig. serialConfigTable. serialConfigEntry. serialTimeout
Enfants
Pas d'enfants disponibles pour cet OID
Détails
OID1.3.6.1.2.1.16.19.10.1.3
Module RMON2-MIB (CISCO)
NomserialTimeout
Accesreadwrite
Statuscurrent
DescriptionThis timeout value is used when the Management Station has initiated the conversation over the serial link. This variable represents the number of seconds of inactivity allowed before terminating the connection on this serial interface. Use the serialDialoutTimeout in the case where the probe has initiated the connection for the purpose of sending a trap.
SyntaxeInteger32 (1...65535)
Module RMON2-MIB (ietf)
NomserialTimeout
Accesreadwrite
Statusdeprecated
DescriptionThis timeout value is used when the Management Station has initiated the conversation over the serial link. This variable represents the number of seconds of inactivity allowed before terminating the connection on this serial interface. Use the serialDialoutTimeout in the case where the probe has initiated the connection for the purpose of sending a trap.
SyntaxeInteger32 (1...65535)
Module RMON2-MIB (Force10-9.14.2.1)
NomserialTimeout
Accesreadwrite
Statusdeprecated
DescriptionThis timeout value is used when the Management Station has initiated the conversation over the serial link. This variable represents the number of seconds of inactivity allowed before terminating the connection on this serial interface. Use the serialDialoutTimeout in the case where the probe has initiated the connection for the purpose of sending a trap.
SyntaxeInteger32 (1...65535)
Module RMON2-MIB (FS)
NomserialTimeout
Accesreadwrite
Statuscurrent
DescriptionThis timeout value is used when the Management Station has initiated the conversation over the serial link. This variable represents the number of seconds of inactivity allowed before terminating the connection on this serial interface. Use the serialDialoutTimeout in the case where the probe has initiated the connection for the purpose of sending a trap.
SyntaxeInteger32 (1...65535)
D. Fournier - 2024