MIB Discovery
1930 modules enregistrés
Chemin
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 4 (private). 1 (enterprises). 351 (stratacom). 110 (basis). 5 (basisServices). 2 (atm). 7 (bbChan). 1 (bbChanCnfGrp). 1 (bbChanCnfGrpTable). 1 (bbChanCnfGrpEntry). 40 (bbChanTestType)
OID : 1.3.6.1.4.1.351.110.5.2.7.1.1.1.40
TXT : iso. org. dod. internet. private. enterprises. stratacom. basis. basisServices. atm. bbChan. bbChanCnfGrp. bbChanCnfGrpTable. bbChanCnfGrpEntry. bbChanTestType
Enfants
Pas d'enfants disponibles pour cet OID
Détails
OID1.3.6.1.4.1.351.110.5.2.7.1.1.1.40
Module CISCO-WAN-BBIF-ATM-CONN-MIB (CISCO)
NombbChanTestType
Accesreadwrite
Statuscurrent
Description The chanTestType starts testing the continuity or delay of a connection. It sends specific cell patterns toward the network and the terminating end of this connection has to be an AXIS or ASI of a BPX in order for this test to be working. The receiving node would loop back when it receives these cells. The test should be done in about couple of seconds. testcon(1) : The testcon tests the continuity of the connection and testdelay uses the same test except that it measures for delay through the network. To test the delay follow this procedure: a- set chanTestType to testdelay b- read chanTestState till it is Pass or Fail c- Read chanTestResult for the delay if it is Pass * Note that the chanTestType would go back to notest when the test is completed To test the continuity follow this procedure: a- set chanTestType to testcon b- read chanTestState till it is Pass or Fail * Note that the chanTestType would go back to notest when the test is completed You CAN NOT select 2 tests back to back, you have to select one and wait for the result and then start the other one.
SyntaxeEnumeration (1-testcon, 2-testdelay, 3-notest)