| Description | This object is used to configure APS architecture mode
on the working/protection line pairs.
All of the following are supported on single slot.
oneToOne(2) is not supported across 2 slots,i.e. the
working and protection slot numbers must be the same in
oneToOne(2).
onePlusOne : This can be supported on the same card
and across 2 cards.
This mode means that the transmit and receive signals
go only over the active line(which could be working or
protection line). (straight cable implied)
oneToOne : This is supported only on the same card
This mode means that the transmit and receive signals
go over the working and protection lines.
(straight cable implied)
anexBOnePlusOne : This can be supported on the same card
and across 2 cards.
This mode is like the onePlusOne mode, except that the
'csApsDirection' can only be bi-directional.
(straight cable implied)
ycableOnePlusOneNok1k2: With Y-cable ignore K1K2 bytes.
This mode is the Y-cable redundancy mode.
straightOnePlusOneNok1k2 : With straight cable, ignore
K1K2 bytes. This mode is like
onePlusOne, but with K1, K2
bytes ignored. |