MIB Discovery
1856 modules enregistr├ęs
Chemin
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 4 (private). 1 (enterprises). 9 (cisco). 10 (ciscoExperiment). 69 (ciscoMetroPhyMIB). 1 (ciscoMetroPhyMIBObjects). 1 (cmPhyIf). 1 (cmPhyIfTable). 1 (cmPhyIfEntry). 3 (cmPhyIfClockRate)
OID : 1.3.6.1.4.1.9.10.69.1.1.1.1.3
TXT : iso. org. dod. internet. private. enterprises. cisco. ciscoExperiment. ciscoMetroPhyMIB. ciscoMetroPhyMIBObjects. cmPhyIf. cmPhyIfTable. cmPhyIfEntry. cmPhyIfClockRate
Enfants
Pas d'enfants disponibles pour cet OID
D├ętails
OID1.3.6.1.4.1.9.10.69.1.1.1.1.3
Module CISCO-METRO-PHY-MIB (CISCO)
NomcmPhyIfClockRate
Accesreadwrite
Statuscurrent
DescriptionThis object allows the management client to set the clock rate across the client side interface. Due to hardware limitations, all values may not be supported. The default value of this object depends on the value of the cmPhyIfProtocol object. When the value of the cmPhyIfProtocol object is reset, the value of this object will be automatically set to the default for that protocol. In case of protocols that support multiple rates, the default value of this object will be the lowest rate possible for that protocol. For example, if the value of cmPhyIfProtocol is set to 'sonet', the default value of cmPhyIfClockRate is set to the OC-3 rate of 155520 kHz. If a non-default value is desired, then this object must be set after the cmPhyIfProtocol object has been reset. This object must be set to a supported clock rate when setting cmPhyIfProtocol to 'unknown'. In 2R mode of operation, this object is not applicable and will have a default value of 0. The value of this object cannot be modified when the cmPhyIfMonitor object is set to 'true' for that interface. Also, this object is not applicable to trunk side interfaces.
UnitekHz
SyntaxeInteger32 (0...10312000)