MIB Discovery

Recherche :

1930 modules enregistrés
Chemin
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 2 (mgmt). 1 (mib-2). 10 (transmission). 238 (adsl2MIB). 1 (adsl2). 1 (adsl2Line). 1 (adsl2LineTable). 1 (adsl2LineEntry). 6 (adsl2LineCmndAutomodeColdStart)
OID : 1.3.6.1.2.1.10.238.1.1.1.1.6
TXT : iso. org. dod. internet. mgmt. mib-2. transmission. adsl2MIB. adsl2. adsl2Line. adsl2LineTable. adsl2LineEntry. adsl2LineCmndAutomodeColdStart
Enfants
Pas d'enfants disponibles pour cet OID
Détails
OID1.3.6.1.2.1.10.238.1.1.1.1.6
Module ADSL2-LINE-MIB (CISCO)
Nomadsl2LineCmndAutomodeColdStart
Accesreadwrite
Statuscurrent
DescriptionAutomode cold start forced. This parameter is defined in order to improve testing of the performance of ATUs supporting automode when it is enabled in the MIB. Change the value of this parameter to 'true' indicates a change in loop conditions applied to the devices under test. The ATUs shall reset any historical information used for automode and for shortening G.994.1 handshake and initialization. Automode is the case where multiple operation-modes are enabled through the adsl2LConfProfAtuTransSysEna object in the line configuration profile being used for the ADSL line, and where the selection of the actual operation-mode depends not only on the common capabilities of both ATUs (as exchanged in G.994.1), but also on achievable data rates under given loop conditions. This object MUST be maintained in a persistent manner.
SyntaxeTruthValue (SNMPv2-TC)
Module ADSL2-LINE-MIB (ietf)
Nomadsl2LineCmndAutomodeColdStart
Accesreadwrite
Statuscurrent
DescriptionAutomode cold start forced. This parameter is defined in order to improve testing of the performance of ATUs supporting automode when it is enabled in the MIB. Change the value of this parameter to 'true' indicates a change in loop conditions applied to the devices under test. The ATUs shall reset any historical information used for automode and for shortening G.994.1 handshake and initialization. Automode is the case where multiple operation-modes are enabled through the adsl2LConfProfAtuTransSysEna object in the line configuration profile being used for the ADSL line, and where the selection of the actual operation-mode depends not only on the common capabilities of both ATUs (as exchanged in G.994.1), but also on achievable data rates under given loop conditions. This object MUST be maintained in a persistent manner.
SyntaxeTruthValue (SNMPv2-TC)
D. Fournier - 2024