MIB Discovery
1930 modules enregistr├ęs
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 2 (mgmt). 1 (mib-2). 10 (transmission). 97 (vdslMIB). 1 (vdslLineMib). 1 (vdslMibObjects). 2 (vdslPhysTable). 1 (vdslPhysEntry). 7 (vdslPhysCurrStatus)
TXT : iso. org. dod. internet. mgmt. mib-2. transmission. vdslMIB. vdslLineMib. vdslMibObjects. vdslPhysTable. vdslPhysEntry. vdslPhysCurrStatus
Pas d'enfants disponibles pour cet OID
Module VDSL-LINE-MIB (ietf)
Description Indicates current state of the Vtu line. This is a bit-map of possible conditions. The various bit positions are: 0 noDefect There are no defects on the line. 1 lossOfFraming Vtu failure due to not receiving a valid frame. 2 lossOfSignal Vtu failure due to not receiving signal. 3 lossOfPower Vtu failure due to loss of power. 4 lossOfSignalQuality Loss of Signal Quality is declared when the Noise Margin falls below the Minimum Noise Margin, or the bit-error-rate exceeds 10^-7. 5 lossOfLink Vtu failure due to inability to link with peer Vtu. Set whenever the transceiver is in the 'Warm Start' state. 6 dataInitFailure Vtu failure during initialization due to bit errors corrupting startup exchange data. 7 configInitFailure Vtu failure during initialization due to peer Vtu not able to support requested configuration. 8 protocolInitFailure Vtu failure during initialization due to incompatible protocol used by the peer Vtu. 9 noPeerVtuPresent Vtu failure during initialization due to no activation sequence detected from peer Vtu. This is intended to supplement ifOperStatus.
SyntaxeBits (0-noDefect, 1-lossOfFraming, 2-lossOfSignal, 3-lossOfPower, 4-lossOfSignalQuality, 5-lossOfLink, 6-dataInitFailure, 7-configInitFailure, 8-protocolInitFailure, 9-noPeerVtuPresent)