MIB Discovery
1930 modules enregistrés
Chemin
MIX : 1 (iso). 3 (org). 6 (dod). 1 (internet). 2 (mgmt). 1 (mib-2). 38 (mdmMib). 1 (mdmMIB). 1 (mdmMIBObjects). 7 (mdmCallControlTable). 1 (mdmCallControlEntry). 6 (mdmCCConnectionFailReason)
OID : 1.3.6.1.2.1.38.1.1.7.1.6
TXT : iso. org. dod. internet. mgmt. mib-2. mdmMib. mdmMIB. mdmMIBObjects. mdmCallControlTable. mdmCallControlEntry. mdmCCConnectionFailReason
Enfants
Pas d'enfants disponibles pour cet OID
Détails
OID1.3.6.1.2.1.38.1.1.7.1.6
Module Modem-MIB (ietf)
NommdmCCConnectionFailReason
Accesreadonly
Statuscurrent
Description Indicates the reason that the last connection or attempt failed. The meaning of each reason code is explained below. unknown: This code means the failure reason is unknown or there has been no previous call. other: This code used when no other code is applicable. Additional vendor information may be available elsewhere. managementCommand: A management command terminated the call. These commands include escaping to command mode, initiating dialing, restoring lines, and disconnecting. inactivityTimeout: The call was terminated because it was inactive for at the minimum duration specified. mnpIncompatibility: The modems are unable to resolve MNP protocol differences. protocolError: An error occured in one of protocol in use. Further information is required to determine in which protocol the error occurred, and the exact nature of the error. powerLoss: The modem lost power and disconnected the call. equipmentFailure: The modem equipment failed. dtrDrop: DTR has been turned off while the modem is to disconnect on DTR drop. (Ref: V.58 cct108TurnedOff) noDialTone: If the modem is to monitor for call progress tones, but the modem has failed to detect dial tone while attempting to dial a number. lineBusy: Busy signal is detected while busy signal detection is enabled, or while the 'W' or '@' dial modifier is used. (Ref: V.58 engagedTone) noAnswer: The call was not answered. voiceDetected: A voice was detected on the call. carrierLost: Indicates that the modem has disconnected due to detection of loss of carrier. In TIA-602, the S10 register determines the time that loss of carrier must be detected before the modem disconnects. trainingFailed: Indicates that the modems did not successfully train and reach data mode on the previous connection. faxDetected: A fax was detected on the call.
SyntaxeEnumeration (1-unknown, 2-other, 3-managementCommand, 4-inactivityTimeout, 5-mnpIncompatibility, 6-protocolError, 10-powerLoss, 11-equipmentFailure, 20-dtrDrop, 30-noDialTone, 31-lineBusy, 32-noAnswer, 33-voiceDetected, 40-carrierLost, 41-trainingFailed, 42-faxDetected)