| Description | This object is used to control the addressed
connUnit's port. Valid commands are:
resetConnUnitPort: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port performs a
vendor-specific 'reset' operation. Examples of
these operations are: the Link Reset protocol,
the Loop Initialization protocol, or a
resynchronization occurring between the
transceiver in the addressed port to the
transceiver that the port is connected to.
bypassConnUnitPort: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port performs a
vendor-specific 'bypass' operation. Examples of
these operations are:
transitioning from online to offline, a
request(NON-PARTICIPATING) command to the
Loop Port state machine, or removal of the
port from an arbitrated loop by a hub.
unbypassConnUnitPort: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port performs a
vendor-specific 'unbypass' operation. Examples
of these operations are:
the Link Failure protocol, a
request(PARTICIPATING) command to the
Loop Port state machine, or addition of the
port to an arbitrated loop by a hub.
offlineConnUnitPort: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port performs a
vendor-specific 'offline' operation. Examples
of these operations are:
disabling a port's transceiver, the Link
Failure protocol, request(NON-PARTICIPATING)
command to the Loop Port state machine, or
removal of the port from an arbitrated loop
by a hub.
onlineConnUnitPort: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port performs a
vendor-specific 'online' operation. Examples
of these operations are:
enabling a port's transceiver, the Link
Failure protocol, request(PARTICIPATING)
command to the Loop Port state machine, or
addition of the port from an arbitrated loop
by a hub.
resetConnUnitPortCounters: If the addressed connUnit
allows this operation to be performed to this
port, the addressed port statistics table counters
will be set to zero.
NOTE: Each implementation may chose not to allow
any or all of these values on a SET. On a read, if
you do not support write, then return invalid. Otherwise
return the last control operation attempted. |
| Syntaxe | Enumeration (1-unknown, 2-invalid, 3-resetConnUnitPort, 4-bypassConnUnitPort, 5-unbypassConnUnitPort, 6-offlineConnUnitPort, 7-onlineConnUnitPort, 8-resetConnUnitPortCounters) |