| Description | This object specifies a glare policy. It is used only if
CAS DS0 directionality of the endpoint is bidirectional,
and is applicable for non R2 variants.
. rptSzOnGlareTmrExp (1): When glare is detected, the GW
will wait for the timeout value specified in the glare
timer object or until incoming call attempt is removed by
the other exchange/switch. If the far end does not back
off due to wrong configuration, and the GW times out,
it reports the seize event to the controlling application.
. rptSzOnGlareDet (2): When glare is detected, the GW will
signal the seizure event to the controlling application.
. rptRelOnGlareTmrExpAndGoOnHook (3): When glare is detected,
the GW will wait for the timeout value specified in the
glare timer object OR until incoming call attempt is
removed by the other exchange/switch. If the far end does
not back off, due to wrong configuration, and the GW times
out, it reports the release event and goes onhook, upon
detection of on hook from the far end the GW will send
the rlc event to the controlling application.
. goOnHookOnGlareDet (4): When glare is detected, the GW
will go on hook and let the far end switch continue. |